G.SHDSL.bis EFM Line Card
G.SHDSL.bis EFM Line Card Ethernet Access Device Networking Accessories Network Communication Solutions Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ) Supplier, Master Distributors, Supply, Supplies | ALTAAS Topologies Sdn Bhd

The G.SHDSL.bis/EFM line card series, which takes advantage of the latest G.SHDSL.bis standard, is a mini-terminal enabling the transport of traffic from Ethernet interface over 5.7M/11.4M/22.8M G.SHDSL.bis link.

The G.SHDSL.bis/EFM line card series is a EFM G.SHDSL.bis transmission equipment for FE signal extension, aggregate FE channel into a G.SHDSL.bis link. The automatic line rate can be up to 5.7 Mbps over 2-wire cooper line. Embedded Operation Channel (EOC) is built between local and remote sides for system configuration, testing, performance and alarm monitoring of E/FE channel and G.SHDSL.bis link.

  • Interoperable with Comet 160x series
  • Point to point Ethernet extension over multiple G.SHDSL.bis copper lines
  • IEEE 802.3ah EFM 2Base-TL bonding technology
  • Compliant with ITU-T G.991.2 standard, TC-PAM 16/32/64/128 line coding
  • 1, 2 or 4 pairs G.SHDSL.bis with 5.7Mbps per pairs
  • Support extension rate up to 15Mbps over a single pair of copper
  • CO and CPE mode selectable
  • Automatic line rate selection with Line Probe enabled
  • Front panel status LED indicators for easy monitoring
  • Easy installation with console, Telnet, WEB GUI and SNMP
  • Front panel test button for easy loop diagnostic
  • Provides extensive diagnostics, including loopback, G.SHDSL.bis performance monitoring
  • Easy software upgrade for field-deployed units via TFTP/HTTP
  • DSL line protection for data transmission
  • Ethernet switching and bridging with VLAN prioritization and QoS

  • SNTU 764S/2W, standalone type G.shdsl.bis NTU, 2-wire, 1 Ethernet port
  • SNTU 764S/4W, standalone type G.shdsl.bis NTU, 4-wire, 1 Ethernet port
  • SNTU 764S/8W, standalone type G.shdsl.bis NTU, 8-wire, 1 Ethernet port
  • All compatible with stand alone Comet 160x series
Line Interface – G.SHDSL.bis
  • Type: 2, 4 or 8-wire
  • Standard: ITU-T G.991.2, ETSI 101 524
  • Bonding protocol: IEEE 802.3ah EFM 2Base-TL
  • Line rate: n x 64Kbps, n=3~89 (2w), 6~178 (4w), 12~356 (8w)
  • Connector: 1xRJ-45
  • Line coding: TC-PAM 16/32/64/128
  • Impedance: 135 W
  • ITU K.21 compliant
DTE Interface – Ethernet
  • Ethernet type: 10/100 BaseT
  • Connector: RJ-45
  • Support 802.3x flow control
  • Auto-MDI/MDIX detection
  • Auto-negotiation for speed and duplex
  • Full duplex / Half duplex support
Timing Source Function
  • Synchronous and Plesiochronous dual clock mode
  • Internal clock
  • Received clock from DSL line
Ethernet L2 function
  • Support 802.1d transparent bridge function
  • Supporting Bridge filter function based on source MAC addresses
  • Scalable per port bandwidth control (Step = 64K, up to 100M)
  • 2K MAC learning address
  • Ethernet packet length up to 1522/*1664 bytes
  • Support 802.3x flow control
  • Provide 802.1q VLAN tagging
  • Support 802.1p QoS facility
  • Configuration via craft port VT-100, Telnet, WEB GUI and SNMP*
  • Multiple Web browsers supported: IE, Firefox, Chrome
  • Support remote management
  • Local and Remote loopback for diagnostic
  • Support Performance Monitoring function
  • Front panel test button for easily loop healthy testing
  • Front panel reset to default button
LED Indicators
  • SNTU 764C:
  • 84(W) x 171(D) x 24(H) mm
Operating Environment
  • Operation Temperature: 0 o C ~ 50 o C
  • Storage Temperature: -40 o C ~ 70 o C
  • Humidity: 90%, non-condensing

Please leave your enquiry here, we will reply as soon as possible.

*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version