Optical Electrical Optical Converter
Optical Electrical Optical Converter Ethernet Access Device Networking Accessories Network Communication Solutions Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ) Supplier, Master Distributors, Supply, Supplies | ALTAAS Topologies Sdn Bhd

This is an Optical-Electrical-Optical (OEO) signal converter, which has two SFP sockets. It can convert two optical digital signals of SFP modules, which maybe different wavelength, different distance or different mode (single mode/multi mode fiber) and same speed at 100M Hz or 1G Hz auto detection. It allows the operator to maintain the Optical-Electrical-Optical with IEEE 802.3ah Link Layer OAM and TS-1000 OAM at CO or CPE mode.


  • Protocol transparent 3R fiber media transponder/repeater (Re-amplification, Re-shaping and Re-clocking)
  • Data rates up to 1G
  • Extend transmission distance from fiber
  • Perform optical repeater function
  • Support SFP DDM (Digital Diagnostics Monitoring)
  • Comply with IEEE 802.1Q Tag VLAN
  • Support Q-in-Q function
  • Maximum Frame size 9K bytes
  • Ethernet bandwidth Control
  • LED indicators for ease of network diagnostic
  • Prompt indication on network failure
  • Firmware upgrade via HTTP
  • Built-in IP-based WEB GUI configuration and maintenance
  • Centralized install with iEAC-16 via web or SNMP management

  • ENTU 763S/GO Stand alone Ethernet repeater
  • ENTU 763C/GO Card type Ethernet repeater
Network Interface
  • Connector type: SFP (MINI-GBIC)
  • SFP type: 100Base-FX SFP modules
  • 1000Base-X SFP modules
  • Support SFP DDM (Digital Diagnostic Monitoring)
  • Temperature, Voltage, Current, Tx Power, Rx Power
  • For detailed wavelength and distance of SFP modules, please refer to SFP Transceivers datasheet
User Interface
  • Connector type: SFP (MINI-GBIC)
  • SFP type: 100Base-FX SFP modules
  • 1000Base-X SFP modules
Ethernet feature
  • Link Status
  • Management IP: static IP or DHCP
  • Ethernet bandwidth control
  • Complies with IEEE 802.1q Tag VLAN (including Q-in-Q)
  • Jumbo frame to 9k bytes
Management & OAM Functions
  • Configuration via craft port VT-100 and WEB GUI
  • Console: RJ45 connector (RS232C)
  • HTTP firmware upgrade
  • RMON counter
  • Front panel test button for easy loop healthy testing
  • Reset button back to factory default
  • Support IEEE 802.3ah Link Layer OAM(network side)

Auto discovery
Link monitoring
Remote loopback test
Remote fault detection

  • Link Fault Reflection
  • Dying Gasp
  • Critical Event
  • Support TS-1000 OAM(network side)

Loopback test
Reset remote device
Get remote device information
Remote port setting

LED Indicators
Power Requirement (Stand alone)
  • AC/DC, DC/DC external power adapter (12V, 0.5A)
  • Power consumption: 3.3W
  • 87(W) x 172(D) x 24(H) mm
Operating Environment
  • Operation Temperature: 0 o C ~ 50 o C
  • Storage Temperature: -20 o C ~ 70 o C
  • Humidity: 90%, non-condensing

Please leave your enquiry here, we will reply as soon as possible.

*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version